Casablanca C66U45B Owner's Manual download pdf (Page 8)

MOUNTING BRACKET INSTALLATION CONT.

FAN PREPARATION

PAPER MOTOR

SHIELD

FIGURE 1.

Prepare for fan installation as follows:

Step 1. Remove the paper shield from the motor as

shown in Figure #1.

Step 2. Loosen the set screw making sure that end

of the Set Screw can not be seen within the motor

coupling as shown in (Figure #2). If so, you will need

to unscrew the Set Screw so that the tip of the Set

Screw does not remain in the path of the downrod.

CAUTION: Failure to fully lock in the

downrod before securely tightening the

set screw may cause the fan to separate

from the downrod and fall during normal

operation.

Perma•Lock™ Downrod

and Ball Assembly

FIGURE 2.

Step 1. Align the slotted holes in the ceiling plate

with the pilot holes you drilled in the wood support

structure. For proper alignment use slotted holes

directly across from each other.

Note: The isolators should be ush against the

ceiling.

Step 2. Place a at washer on each of the two

3” wood screws and pass the screws through the

slotted holes in the ceiling plate into the pilot holes

you drilled.

Step 3. Tighten the screws into the 9/64” pilot

holes; do not use lubricants on the screws. Do not

over tighten.

Joist

Ceiling Fan

Approved

Wiring Box

Washer

Wood

Screw

Note: On sloped ceilings, align

the canopy opening toward

the top or peak of the room.

PREPARATION HARDWARE

Set Screw

Allen Wrench

Canopy

Trim Ring

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 21 22

Comments to this Manuals

No comments

Casablanca C66U45B Owner's Manual Page 8

Comments to this Manuals

Related products and manuals for Household fans Casablanca C66U45B