Casablanca Wilderness Owner's Manual download pdf (Page 7)

Wi l d e r n e s s

™

Step 10. To reach the blade holder mounting holes in the fan

motor the switch housing cap must be removed. Take out the

two 8-32 X

/8” screws securing the switch housing cap and

remove. Put the two (2) screws aside for the moment, they

will be used in Step 15 to install the switch housing cap after

the blades are installed.

SWITCH HOUSING CAP

MOUNT SCREW

8-32 X

/8”

(2)

SWITCH

HOUSING

CAP

Note: Save these two screws–they

will be used in Step 15!

BLADE SCREW

AND WASHER

(4 PER BLADE)

BLADE

HOLDER

BLADE HOLDER

SCREW

(2 PER BLADE)

Step 11. Attach each blade to a blade holder by ﬁrst press-

ing the blade badge into the blade, then installing the blade

holder using the four blade screws provided for each blade.

Using a screwdriver tighten securely by hand only.

Repeat for each blade assembly

BLADE SCREW

AND WASHERS

(4 PER BLADE)

BLADE

HOLDER

BLADE

REMOVE DUMMY SWITCH HOUSING & SHIPPING BLOCK

BLADE & BLADE HOLDER HARDWARE

BLADE BADGE INSTALLATION

1 2 3 4 5 6 7 8 9 10 11 12 13 14

No comments

Casablanca Wilderness Owner's Manual Page 7