Casablanca WHITMAN Owner's Manual Page 26

  • Download
  • Add to my manuals
  • Print
  • Page
    / 55
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 25
20
Set-Up - Analog Input Levels
This function allows the user to adjust the relative
ANALOG
input
LEVEL
of each input source for those
modes which require an analog to digital conversion. For example a VCR used with Pro Logic
(DOLBY
PRO
) or Simple
MATRIX
modes. This function does not affect source levels when a digital audio input is
selected. The relative range is -22 dB to +19 dB.
To access this menu page from the
MAIN
menu, press
SET-UP
once, then press the
ANLG LVLS
(button
4
)
once. The analog levels sub menu is shown in figure 15.
* * *
Figure 15 - Front Panel Display of the SET-UP: Analog Input Levels Sub Menu
Press buttons
1
-
6
to select an input. The LED above the selected button will light. Press the
LEVEL UP
or
LEVEL DOWN
button(s) to adjust the relative input level. The
A-D
button is not used in this sub menu and
therefore disabled.
Press the
SET-UP
button once to return to the
SET-UP
menu (shown in figure 9). Press
SET-UP
once more
to return to the
MAIN
menu and store any changes. The
MASTER VOLUME
can be controlled using the
LEVEL
LEFT
/
RIGHT,
for level down/up respectively, in this sub menu.
Note
: To obtain the best performance from the analog to digital conversion process, levels should be set so
that the loudest passages from the source material cause the
-18
,
-12
and
-6
dB
ANALOG
input
LEVEL
LEDs on the front panel to light. Setting the input level too high will cause all four LEDs to light, thus clipping
the input signal and causing distortion.
Analog output levels may vary considerably for different input sources. Program material from a given input
source should not vary as greatly. Therefore the
ANALOG
input
LEVEL
for a given source should not have
to be adjusted very often. If, however, the input
ANALOG LEVEL
LEDs are not lit during the loudest
passages from an analog source, the user should increase the
ANALOG
input
LEVEL
for that source in
order to ensure a good signal to noise ratio.
Page view 25
1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 54 55

Comments to this Manuals

No comments