Casablanca Reverie Owner's Manual download pdf (Page 11)

REVERIE

™

Light Assembly Installation

Step 11a. Using screw pack “E” and screwdriver provided;

install three screws into the light assembly adaptor plate,

as shown.

Step 11b. Connect the light assembly connector to the

motor connector.

Step 11c. Carefully tuck the wires and align the keyhole

slots in the light assembly with the three screws in the

adaptor plate. Turn counter clockwise to align the keyhole

slots with the three screws.

Step 11d. Securely tighten all three screws by hand only.

Install Incandescent Bulbs

Step 12. Screw in two 60- watt B-10 Candelabra-base

bulbs.

Glass Installation

Step 13a. Remove ﬁ nial and cap from light assembly.

Step 13b. Insert the threaded rod from the light assembly

through the hole in the glass shade, as shown.

Step 13c. Insert the cap, then thread the ﬁ nial onto the

threaded rod. Tighten securely.

LIGHT FIXTURE INSTALLATION

SWITCH HOUSING HARDWARE (not to scale)

Light Assembly

Screw Pack E:

Light Assembly Screws (3)

60-watt B-10 bulb

(Candelbra-base)

CAUTION:

Over tightening the ﬁ nial can cause glass to break.

Glass Shade

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17 18

No comments

Casablanca Reverie Owner's Manual Page 11