Casablanca WHITMAN Owner's Manual download pdf (Page 33)

REMOTE CONTROL OPERATIONS

This section describes the functionality of the Casablanca’s hand held remote only. For front panel

functionality descriptions, please refer to the section entitled

FRONT PANEL OPERATIONS

on page 9.

Descriptions for remote buttons/functionality not covered in this section can be found in the preceding

REMOTE CONTROL LAYOUT

section. Features and functional descriptions which are common to both front

panel and remote operations are covered in the

FRONT PANEL

section only and therefore not repeated in

this section.

Input Select Menu and Non Menu Functions

When the rear panel

MAIN

POWER

switch is turned on, the Casablanca enters standby mode. Pressing the

POWER

button once will result in the video monitor displaying a start-up routine and then the

INPUT

SELECT

menu for

seconds, where

represents the time parameter value that is stored in the

SET-UP:

MISCELLANEOUS

sub menu,

DISPLAY

feature. Figure 22 shows an example of this menu.

Figure 22 - Video Monitor Display of the INPUT SELECT Menu

Pressing buttons

through

SELECT UP/DOWN

will select a desired input, or audio source. An arrow

will point to the currently selected input.

Pressing the

LEVEL UP/DOWN

buttons will adjust the master volume for all speakers. This value ranges

from

(relative maximum) and will be shown on the video monitor for

seconds.

Pressing the

LEVEL LEFT/RIGHT

buttons will adjust the

value between

OFF

and

, and will be

shown on the video monitor for

seconds. Refer to page 9 for additional information pertaining to the

Pressing the

A-D

button will toggle the currently selected input between

ANALOG

and

DIGITAL

and will be

shown on the video monitor for

seconds. Select either

ANALOG

DIGITAL

, whichever corresponds to the

signal format being sent to the currently selected input. Please refer to page 10 for additional information

regarding the

A-D

button and priority switching.

The

MUTE

button will toggle the audio on and off in all speakers each time it is pressed. When the mute

function in enabled, the

LEVEL

parameter value will be replaced with the word

MUTING,

which will remain

displayed on monitor for

seconds. If the

MUTE

button is pressed again or the

LEVEL

DOWN

buttons

are pressed, the word

MUTING

will be replaced with the

LEVEL

parameter value . This is assuming that

the selected input is set to

DIGITAL

, that data exists at this input. i.e. the

LOCK

LED is on. The

MUTE

feature is active in all menus.

The

DISPLAY

button will toggle the front panel LCD brightness between off, low, medium and high. This

feature will have no effect on the video display.

Repeatedly pressing the

PHASE

button simultaneously toggles all of the main audio output’s phase between

and

180

degrees, and displays this on the monitor for

seconds. The

PHASE

parameter is only adjustable

from the remote since its effect can be best detected from the listening position.

INPUT SELECT

1 LD1

2 VCR1

→

→→

→ 3 SAT

4 TV

5 DAC

6 TAPE

ANALOG

EQ: 1

PHASE:0 LEVEL:42

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 54 55

Comments to this Manuals

No comments

Casablanca WHITMAN Owner's Manual Page 33

Comments to this Manuals

Related products and manuals for Receiver Casablanca WHITMAN